There's no sound, The cd does not play, The remote does not function – Sony CDP-CA80ES User Manual

Page 24: The player functions incorrectly, Troubleshooting specifications, Additional information

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Additional Information

Troubleshooting

Specifications

If you experience any of the following difficulties while.,
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.

There's no sound.

^Check that the player is connected securely.
^Make sure you operate the amplifier correctly.
^Adjust the output level using the LINE OUT

LEVEL +/ - buttons on the remote.

The CD does not play.

•^There's no CD inside the player ("-NO DISC-"

appears). Insert a CD.

^Place the CD with the label side up on the disc

tray correctly.

^Clean the CD (see page 20).
■^Moisture has condensed inside the player.

Remove the disc and leave the player turned on
for about an hour (see page 20).

^Place the CD in the correct position on the disc

tray.

The remote does not function.

^Remove the obstacles in the path of the remote

and the player.

-

“♦Point the remote at the remote sensor B on the

player.

^Replace all the batteries in the remote with new

ones if they are weak.

^Set the CD 1 / 2 / 3 switch on the remote

according to the position of the COMMAND
MODE selector at the rear panel of the player.

The player functions incorrectly.

^The microcomputer chips may be operating

incorrectly. Turn the power off, then turn it
back on to reset the player.

Compact disc player

Laser

Laser output

Frequency response

Signal-to-noise ratio

Dynamic range

Harmonic distortion

Channel separation

Semiconductor laser (X. = 780 nm)
Emission duration: continuous

Max 44.6 pW*

This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical

Pick-up block with 7 mm aperture.

2 Hz to 20 kHz ±0.3 dB

More than 117 dB

More than 99 dB

Less than 0.0025%

More than 110 dB

Output

lack
type

Maximum
output
level

Load
impedance

LINE OUT

Phono

2 V

Over 10 kilohms

jacks

(at 50 kilohms)

DIGITAL OUT

Optical

-18 dBm

Wave length: 660 nm

(OPTICAL)

output

connector

PHONES

Stereo

15 mW

32 ohms

phone jack

General

Power requirements

Where purchased

Power requirements

USA

120 V AC, 60 Hz

Europe

220 V-230 VAC, 50/60 Hz

Other countries

no V - 120 V AC or 220 V - 240 V AC

adjustable, 50/60 Hz

Power consumption

15 W

-

Dimensions (approx.)

430x 125x400 mm

(w/h/d)

(17 X 5 X 15 3/4 in.) incl. projecting

parts

Mass (approx.)

7.0 kg (15 lbs 7 oz)

Supplied accessories

Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (1)
Sony SUM-3 (NS) batteries (2)

Design and specifications are subject to change without notice.

21

Advertising