Casio CTK900 - Manual (Page 28)

E-25
Applying Effects to Tones
You can save up to 100 modified DSPs in the user area for
later recall when you need them.
• User DSP areas 100 through 199 initially contain the same
data as DSP types 000 through 099.
1.
After making the DSP parameter settings you
want, press the [
] CURSOR button.
• This causes the DSP number of the user area where the
DSP will be saved to flash on the display.
2.
Use the [+] and [–] buttons to select the user DSP
area number where you want to save the new
DSP.
• You can select a user DSP area number in the range of
100 to 199 only.
3.
After the user DSP area number you want is
selected, press the [ ] CURSOR button.
• Use the [+] and [–] buttons to scroll through letters at
the current cursor location.
• Use the [ ] and [ ] CURSOR buttons to move the
cursor left and right.
• See the page E-45 for information about inputting text.
4.
After everything is the way you want, press the
[
] CURSOR button to store the effect.
• This will display a confirmation message asking
whether you really want to save the data. Press the
YES button to save the data.
• The message “Complete” appears momentarily on the
display, followed by the tone or rhythm selection
screen.
Checking the DSP button will tell you whether or not DSP is
enabled for the tone that is currently selected for a part. The
DSP button will be lit for a tone that is DSP enabled (DSP line
ON), and unlit for a tone that is DSP disabled (DSP line OFF).
For example, when you move each part while using the split/
layer function, the DSP button lights or goes out in
accordance with that parts setting.
Pressing the DSP button toggles the tone of the part you are
currently playing on the keyboard between enabled (DSP line
ON) and disabled (DSP line OFF).
1.
Press the DSP button to toggle DSP line for the
currently selected part on and off.
Perform the following steps to select REVERB.
1.
Press the EFFECT button, so the pointer appears
next to EFFECT on the display screen.
1
Pointer
2.
Press the [ ] CURSOR button once.
• This displays the reverb editing screen.
• The reverb type setting screen (step 4) will appear
automatically about fives seconds after you press the
button.
3.
Press the [ ] CURSOR button.
4.
Use the [+] and [–] buttons or the number buttons
to scroll through the reverb types until the one you
want is displayed, or use the number buttons to
input the reverb number you want to select.
• See the list on page A-13 for information about the
types of REVERB effects that are available.
• Here you could also change the parameters of the
effect you selected, if you want. See “Changing the
Settings of REVERB Parameters” on page E-26 for
more information.
Saving the Settings of DSP Parameters
DSP Button
To turn DSP line on and off
Selecting REVERB
1
707A-E-027A