Casio CTK900 - Manual (Page 42)

E-39
Mixer Function
z Chorus Send (Range: 000 to 127)
This parameter controls how much chorus send is applied to
a part. A setting “000” turns chorus send off, while a setting
of 127 applies maximum chorus send.
• “Chorus Send” does not work with drum sounds.
z DSP Line (Settings: on, oFF)
You can use this parameter to turn DSP line off for a particular
channel, or to turn it on.
z DSP Level (Range: 0 to 127)
Sets the post-DSP volume.
z DSP Pan (Range: –64 to 0 to 63)
Sets the post-DSP stereo pan.
z DSP System Reverb Send (Range: 000 to 127)
This parameter adjusts how much reverb is applied to all
parts.
z DSP System Chorus Send (Range: 000 to 127)
This parameter adjusts chorus.
• Changing the tone, volume, pan pot, coarse tune, fine tune,
reverb send, or chorus send setting causes the
corresponding MIDI message to be output from the MIDI
terminal.
• Changing the tone settings changes the tone, octave shift,
reverb send, chorus send, and DSP line * parameter settings.
* When DSP is off (See the note on page E-24).
• Turning on the Mixer’s DSP line parameter (page E-24)
causes the settings of the DSP Pan, DSP System Reverb
Send, and DSP System Chorus parameters to be used in
place of the Pan Pot, Reverb Send, and Chorus Send
parameter’s settings.
DSP Part Parameters
C e n d S o h
D i n e L P S
D L v e l e P S
D a n P P S
D v S n d b R .
D h S n d o C .
707A-E-041A