LG SXS LRSC 26980TT - Manual (Page 25)

Freezer
Compartment
Lamp
Dispenser Lamp
Freezer
Compartment
Shelf
Door Rack and
Support
Ice Storage Bin
After Dispenser
Is Used
How to Dismantle Parts
NOTE
: : :'.l;Tisrtiahi:.iii:K'j js.d oncMt) tlie.rt;\?orstr^s(:;qrH;nt:e f!l . a s s e r t v [ ) l y ; . : : : .... ............. .............
T-w.Si.|re r!Xi:jri):;Ji.
111 Novf.'t: appiy sow
('i .tfie i.iowéf .|. j I!, k ; i ..Ivel^ie .dlsriiant.liiH]s)tui.asseiiH?ly:. : : :
ere forco to .dismantle, parts;: Rarfs. ttiay.bo damaged:, : . . . . . . . . . :
To remove the lamp cover pull out firmly on the
lamp cover and rotate. This should expose the bulb.
Turn the bulb counterclockwise, Max. 40 W
refrigerator bulb is used and can be purchased at a
service center.
Seperate the lamp by pulling it out, and then
remove the lamp. Max. 15 W refrigerator bulb
is used and can be purchased at a service
center.
To remove a shelf, lift the left part of the shelf
a bit, push it to direction ®, lift the right part to
direction @, and take it out.
Lift the door rack holding both sides ® and
pull it in direction @.
Hold the ice storage bin as shown in the figure
to the right and pull it out (D while slightly lifting
it®.
■ It is recommended not to dismantle the ice
storage bin unless it is necessary.
" Use both hands to remove the ice bin to avoid
dropping it.
■ If the ice bin does not slide into place easily,
twist the drive device slightly.
The water collector has no self-drainage
function. It should be cleaned regularly.
Remove the cover by pulling the front side of
water collector cover and dry it with a cloth.
I
w ii