Changing motor voltage, Awarning, 240 volt connection – Craftsman 152.213371 User Manual
Page 16: Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING MOTOR VOLTAGE
A
warning
MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.
The motor supplied with your Dust Collector is a dual
voltage 120/240-volt, single-phase motor. It is shipped
wired for 120-volt application. If you choose 240-volt to
operate your machine, the following instructions must
be followed.
A
warning
If you are unsure of electrical connections or codes,
contact a certified electrician. All local and state codes
must be followed.
Refer to GROUNDING INSTRUCTION section before
proceeding:
1. DISCONNECT THE DUST COLLECTOR FROM
THE POWER SOURCE.
2. Remove the switch box cover.
3. The motor has four leads. Reconnect the motor
leads for chosen voltage, as shown in the wire
diagram. See figure 19.
4. The START/STOP switch is a double pole switch.
No changes are required for 120/240 volt operation.
5. Replace the plug with the correct plug with ground
for voltage required. The new plug must meet all
local and state electrical codes.
6. Reassemble switch box cover.
ON/OFF SWITCH
CIRCUIT BREAKER
... 1. .1
3 / \
2 1 iviu i UH 1
—
‘'XI
4 V
J
120 VOLT CONNECTION
ON/OFF SWITCH CiRCUIT BREAKER
A
______----------------------------------- ^
<
240 VOLT CONNECTION
Fig. 19
16