Attaching the chute deflector, Assembly – Craftsman 247.776370 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ATTACHING THE CHUTE DEFLECTOR
1. a. Remove the wing knobs from each side of the lower impeller
housing. See Figure 3.
b. Remove the hex lock nut, spacers, and hex bolt from the top of
the impeller housing.
2.
a. Align the chute deflector in position on the discharge opening
and insert hex bolt with spacer through hinge on chute
deflector (spacers fit inside of hinges). See Figure 4.
b. Place second spacer over hex bolt inside other hinge and
secure with hex lock nut.
c. Secure both sides of chute deflector to impeller housing using
wing knobs previously removed.
ATTACHING THE CHIPPER CHUTE
1.
a. Remove the three cupped washers and hex nuts from weld
studs around the opening on the side of the impeller housing.
See Figure 5.
b. Remove the hex bolts, flat washers, and lock nuts from the two
holes on the upper end of the support brace.
9