Craftsman 315.111640 - Manual (Page 7)

OPERATION
A WARNING: Always wear safety goggles or
safety glasses with side shields when operating
tools. Failure to do so could result in objects
being thrown into your eyes, resulting in possible
serious injury.
A WARNING: Do not allow familiarity with your
screwdriver to make you careless. Remember
that a careless fraction of a second is sufficient
to inflict severe injury.
CHARGING YOUR SCREWDRIVER
This tool has been shipped in a low charge condition
to prevent possible problems. Therefore, you should
charge it at least 3 hours prior to use.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (driving
screws followed by recharging) for them to become
fully charged.
TO CHARGE
■ Charge screwdriver only with the charger pro­
vided.
■ Make sure power supply is normal house
voltage, 120 volts, 60 Hz, AC only.
Connect charger to screwdriver by inserting
charger plug into input jack. As shown in figure 1,
input jack is located on the top of your screw­
driver.
Make sure charger plug and input jack are prop­
erty connected.
Connect charger to power supply.
The charge indicator light (LED) indicator, which is
located on the back of the screwdriver, will light up
when charger is properly connected to power
supply. This red light indicates your screwdriver is
charging and will remain on until charger is
disconnected from power supply.
After normal usage, a minimum of 3 hours of
charging time is required to be fully charged.
Do not operate the tool while it is connected to
the charger. The driving ability will not increase.
Do not place charger in an area of extreme heat
or cold. It will work best at normal room tempera­
ture.
k CAUTION: Your screwdriver contains special
* high temperature batteries to help prevent battery
damage when left on charge for extended periods
of time. However, once the batteries become fully
charged, we recommend that you unplug the
charger from power supply and disconnect it from
the screwdriver.