Craftsman 247.775860 - Manual (Page 6)

3. TOOLS REQUIRED
1. 1/2" or Adjustable Wrenches
2. 7/16" or Adjustable Wrenches
3. Funnel
4. DISCONNECTING SPARK PLUG
• Disconnect the spark plug wire and move it
away from the spark plug before assembiing the
chipper-shredder. See figure 2.
5. ATTACHING DISCHARGE CHUTE
• Remove the wing knobs from each side of the
discharge opening on the chipper-shredder. See
figure 3.
• Using two 7/16" wrenches, remove hex iock
nut, two spacers, and the hex boit from top of
the housing assembiy. For easy assembly, do
not remove the second spacer from the hex bolt.
• Place the discharge chute in position on the
discharge opening. Insert hex bolt and spacer
through hinge on discharge chute and housing
(spacer fits inside of hinge). See figure 3 inset.
• Piace second spacer over hex boit inside the
other part of the hinge. Secure with hex lock nut.
Tighten securely.
• Secure both sides of discharge chute to housing
using wing knobs that you earlier removed.
Tighten wing knobs.
6. ATTACHING HOPPER ASSEMBLY
• Remove the 8-3/8” iong hex bolt and the hex nut
from the bottom of the inlet guide opening.
• Piace the hopper assembiy on the ground and
hoid it in the position shown in step 1 in figure 4.
• Holding the hopper, push hopper pivot door
down inside the hopper. See figure 4.
• Siide the hopper assembiy towards the chipper­
shredder housing so that the upper guide on the
hopper assembly slides under the stop washer
on each side of the inlet guide. See figure 4.
• Align the two hoies (one on each side) of the
iower hopper with the two hoies (one on each
side) of the iniet guide.
• insert the hex boit (that you earlier removed)
from the ieft through the hole on the hopper and
the iniet guide. Insert the hex nut onto the bolt
from the other side. See figure 4 inset.