Craftsman 917.275021 - Manual (Page 26)

R.H.
TO REPLACE MOWER BLADE DRIVE
BELT
Park the tractor on level surface. Engage
parking brake.
1. Remove mower drive belt (See “TO
REPLACE MOWER DRIVE BELT” in
this section of this manual).
2. Remove mower (See "TO REMOVE
MOWER" in this section of this
manual).
3. Remove screws from L.H. mandrel
cover and remove cover.
4. Carefully roll belt off L.H. mandrel
pulley.
5. Remove belt from center mandrel
pulley, idler pulley, and R.H. mandrel
pulley.
6. Remove any dirt or grass which may
have accumulated around mandrels
and entire upper deck surface.
7. Check secondary idler arm and idler
pulley to see that they rotate freely.
8. Be sure spring is hooked in secondary
idler arm and secondary spring arm.
9. Install new belt in lower groove of R.H.
mandrel pulley, idler pulley, and
center mandrel pulley as shown.
10. Carefully roll belt over L.H. mandrel
pulley. Make sure belt is in ail
grooves properly.
11. Reinstall L.H. mandrel cover.
12. Reinstall mower to tractor (See
“INSTALL MOWER AND DRIVE
BELT" in the Assembly section of this
manual).
13. Reassemble mower drive belt (See
“TO REPLACE MOWER DRIVE BELr
in this section of this manual).
Secondary
L H, Idler Arm
Mandrel
Idler
Pulley
Spring
Secondary
Spring Ann
Center
Mandrel
R.H.
Mandrel
TO ADJUST ATTACHMENT CLUTCH
The electric clutch should provide years
of service. The clutch has a built-in brake
that stops the pulley within 5 seconds.
Eventually, the internal brake will wear
which may cause the mower blades to
not engage, or, to not stop as required.
Adjustments should be made by a Sears
or other qualified service center.
1. Make sure attachment clutch and
ignition switches are in “OFF" position.
Adjust the three nylon locknuts until
space between clutch plate and rotor
measures .012" at all three slot
locations cut in the side of brake plate.
2 .
26