Storage, Handle, Other – Craftsman 917.77341 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

STORAGE

Immediately prepare your trimmer for storage
at the end of the season or if the unit will not
be used for 30 days or more.

TRIMMER

When trimmer is to be stored for a period of

time, clean it thoroughly, remove alt dirt,
grease, leaves, etc. Store in a clean, dry area.
• Clean entire trimmer (See "CLEANING" in

the Maintenance section of this manual).

• Lubricate as shown in the Maintenance

section of this manual.

• Be sure that all nuts, bolts, screws, and pins

are securely fastened. Inspect moving

parts for damage, breakage and wear.

Replace if necessary.

• Touch up all rusted or chipped paint

surfaces: sand lightly before painting.

HANDLE
You can fold your trimmer handle for storage.
• Loosen handle knobs enough to allow

upper handle to be folded forward.

IMPORTANT: When folding the handle for

storage or transportation, be sure to fold the

handle as shown or you may damage the
control cables.

Upper
handle

Handle knob

ENGINE

FUELSYSTEM
IMPORTANT: It is important to prevent gum

deposits from forming in essential fuel system

parts such as carburetor, fuel filter, fuel hose
or tank during storage. Also, experience
indicates that alcohol blended fuels ( called
gasoho! or using ethanol or methanol) can
attract moisture which leads to separation and
formation of acids during storage. Acidic gas
can damage the fuel system of an engine

while in storage.

• Drain the fuel tank.
• Start the engine and let it run until the fuel

lines and carburetor are empty.

• Never use engine or carburetor cleaner

products in the fuel tank or permanent

damage may occur,

• Use fresh fuel next season.

NOTE: Fuel stabili

2

er is an acceptable

alternative in minimizing the formation of fuel

gum deposits during storage. Add stabilizer

to gasoline in fuel tank or storage container.
Always follow the mix ratio found on stabilizer

container. Run engine at least 10 minutes

after adding stabilizer to allow the stabilizer to

reach the carburetor. Do not drain the gas
tank and carburetor if using fuel stabilizer.
ENGINE OIL

Drain oil (with engine warm) and replace with

clean engine oil. (See "ENGINE" in the

Maintenance section of this manual).
CYLINDER
• Remove spark plug.

• Pour one ounce (29 ml) of oil through

spark plug hole into cylinder.

• Pull starter handle slowly a few times to

distribute oil.

• Replace with new spar1< plug.
OTHER
• Do not store gasoline from one season to

another.

• Replace your gasoline can if your can

starts to rust. Rust and/or dirt in your
gasoline will cause problems.

• If possible, store your unit indoors and

cover it to give protection from dust and dirt.

• Cover your unit with a suitable protective

cover that does not retain moisture. Do

not use plastic. Plastic cannot breathe

which allows condensation to form and will

cause your unit to rust.

IMPORTANT: Never cover trimmer while
engine and exhaust areas are still warm.

^CAUTION: Never store the trimmer

with gasoline in the tank inside a building
where fumes may reach an open flame or

spark. Allow the engine to cool before
storing in any enclosure.

14

Advertising