Craftsman 917.77341 - Manual (Page 5)

ASSEMBLY
Read these instructions and this manual in its
entirety before you attempt to assemble or
operate your new trimmer.
IMPORTANT: This trimmer is shipped
WITHOUT OIL OR GASOLINE in the engine.
Your new trimmer has been assembled at the
factory with the exception of those parts left
unassembled for shipping purposes. All parts
such as nuts, washers, bolts, etc., necessary
to complete the assembly have been placed
in the parts bag. To ensure safe and proper
operation of your trimmer, all parts and
hardware you assemble must be tightened
securely. Use the correct tools as necessary
to ensure proper tightness.
Loose Parts Packed Separately
Safety
Goggles
20 oz.
Bottle of oil
TO REMOVE TRIMMER FROM CARTON
• Remove loose parts included with trimmer.
• Cut down two end comers of carton and
lay end panel down flat.
• Remove all packing materials.
• Roll trimmer out of carton and check carton
thoroughly for additional loose parts.
HOWTO SET UP YOUR TRIMMER
TO UNFOLD HANDLE
IMPORTANT: Unfold handle carefully so as
not to pinch or damage control cables.
• Loosen handle knobs enough to allow
upper handle to be unfolded from the
shipping position.
• Raise upper handle section into place on
lower handle and tighten handle knob.
• Remove handle padding holding trimmer
head control bar to upper handle.
Trimmer Lines
(2) Sets
(0.130 diameter
X16.75 inches iong)
Upper handle
Lift up
Handle knob
Lower handle