Craftsman 247.28911 - Manual (Page 11)

ASSEMBLY
wheel and push downward until it “clicks” into place.
Attaching The Seat
If the seat for your tractor was not attached at the factory, refer to the
following steps.
NOTE: For shipping reasons, seats are either fastened to the tractor
seat's pivot bracket with a plastic tie, or mounted backward to the pivot
bracket. In either case, free the seat from its shipping position and
remove the adjustment knob from the bottom of seat before proceed­
ing with the instructions below.
1. Position the shoulder screws (found on the base of the seat)
inside the slot openings in the seat pivot bracket.
Fig. 4.
2. Slide the seat slightly rearward in the seat pivot bracket, lining
up the center rear slot in the pivot bracket with the remaining hole
in the seat's base.
ment knob removed earlier.
To adjust the position of the seat, loosen the adjustment knob
on the bottom of the seat. Slide the seat forward or backward as
desired. Retighten the adjustment knob.
Tire Pressure
4.
AWARNING
Maximum tire pressure under any circumstances is 30 psi. Equal
tire pressure should be maintained at all times. Never exceed the
maximum inflation pressure shown on the sidewall of the tire.
The recommended operating tire pressure is:
Approximately 10 psi for the rear tires
Approximately 14 psi for the front tires
IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pres­
sure could cause the cutting deck to mow unevenly.
1 1