The recommended operating tire pressure is, Battery, A caution – Craftsman 247.28911 User Manual

Page 24: Jump starting, Awarning, Charging, Service and maintenance

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SERVICE AND MAINTENANCE

Remove the bow-tie cotter pin securing the deck stabilizer rod to

the deck. Slide the deck lift rod from the mounting bracket on the
deck as seen in Fig. 18.

by removing the bow-tie cotter pin which secures it. Remove the
spring from the deck idler bracket. See Fig. 19.

underneath the tractor.

TIRES

AWARNING

Never exceed the maximum inflation pressure shown on the sidewall

of tire.

The recommended operating tire pressure is:

Approximately 10 psi for the rear tires

Approximately 14 psi for the front tires

IMPORTANT: Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire pres­
sure could cause the cutting deck to mow unevenly.

BATTERY

California Proposition 65 WARNING! Battery posts, terminals, and
related accessories contain lead and lead compounds, chemicals
known to the State of California to cause cancer and reproductive
harm. Wash hands after handling.

A CAUTION

If removing the battery, disconnect the NEGATIVE (Black) wire

from its terminal first, followed by the POSITIVE (Red) wire. When

re-installing the battery, always connect the POSITIVE (Red) wire to
its terminal first, followed by the NEGATIVE (Black) wire.

JUMP STARTING

AWARNING

Never jump start a damaged or frozen battery. Be certain the vehicles

do not touch, and ignitions are off. Do not allow cable clamps to
touch.

1. Connect positive

(+)

cable to positive post

(+)

of your tractor’s

discharged battery.

2. Connect the other end of the cable to the (positive +) post of the

jumper battery.

3. Connect the second cable (negative -) to the other post of the

jumper battery.

4. Connect the other end of the negative cable to the engine block of

the tractor, away from the battery. Attach to an unpainted part to
assure a good connection.

AWARNING

If the jumper battery is installed on a vehicle (i.e. car, truck), do NOT
start the vehicle’s engine when jump starting your tractor.

5. Start the tractor (as instructed earlier in this section of this

manual).

6. Set the tractor’s parking brake before removing the jumper cables,

in reverse order of connection.

CHARGING

AWARNING

Batteries give off an explosive gas while charging. Charge the battery
in a well ventilated area and keep away from an open flame or pilot
light as on a water heater, space heater, furnace, clothes dryer or

other gas appliances.

A CAUTION

When charging your tractor’s battery, use only a charger designed for

12V lead-acid batteries. Read your battery charger’s Owner’s Manual

prior to charging your tractor’s battery. Always follow its instructions
and heed its warnings.

24

Advertising