Craftsman 358.792443 - Manual (Page 5)

ASSEMBLY
CARTON CONTENTS
Check carton contents against the fol­
lowing list.
Model 358.792443
• Brushcutter attachment
• Handlebar
• Handlebar mounting bracket for 1''
{2.5 cm) shaft
• Handlebar mounting bracket for 7/8"
(2.2 cm) shaft
• Bracket cover (2)
• Shoulder strap
• Upper shoulder strap clamp
• Lower shoulder strap clamp (with
spacer tabs)
• Handlebar bracket screws (4)
• Shoulder strap clamp screws (2)
• 4-point weed blade (assembled on
brushcutter attachment)
• Large nut for installing blade
• Retaining washer
• Cupped washer
• Metal shield (assembled on brush­
cutter attachment)
• Trimmer head
• Plastic shield
• Wing nut (screwed onto plastic shield)
• Attachment Hanger
• Hex Wrench
• Container of line
Examine parts for damage. Do not use
damaged parts.
NOTE; if you need assistance or find
that parts are missing or damaged, call
1-800-235-5878.
ASSEMBLY
^WARNING: If received assembled,
repeat all steps to ensure your unit is
properly assembled and all fasteners
are secure.
• A hex wrench (provided) is required
for assembly.
INSTALLING BRUSHCUTTER AT­
TACHMENT
CAUTION: When removing or instal­
ling attachments, place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Coupler
TIGHTEN
LOOSEN
Knob
2
.
4.
5.
Remove the shaft cap from the
brushcutter attachment (if present).
Position locking/release button of
attachment into guide recess of
coupler.
Push the attachment into the cou­
pler until the locking/release button
snaps into the primary hole.
Before using the unit, tighten the
knob securely by turning clock­
wise.
Coupler Primary Hole
Guide Recess
Uooer Looking/
Release
Button
Attachment
a WARNING: Make sure the lock­
ing/release button is locked in the pri­
mary hole and the knob is securely
tightened before operating the unit. Us­
ing the wrong hole could lead to serious
injury or damage to the unit.
Locking/Reiease ,
Button in Primary Hole