Assembly of the snow thrower – Craftsman 486.24839 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Hold this drawing above you while viewing the
Clutch/ldler Assembly from underneath the
tractor. Right and left in the drawing wiil be the
reverse of the viewer's right and ieft.
ENGINE
PULLEY
KEEPER
Leftside
of Tractor
IDLER
PULLEY—^
L
FIGURE 22
VIEWED FROM UNDERNEATH
ASSEMBLY OF THE SNOW THROWER
• Place the lift handle into the lift bracket on the right
side of the snow thrower. Fasten the handle to the
bracket using two 5/16“ x 1-3/4" hex bolts, 5/16"
lock washers and 5/16" hex nuts. See figure 23.
NOTE: Be sure the lift release cable's plastic covering
remains inserted into the trigger assembly while
performing the next step.
• Push the lift handle down into the locked position.
Insert the end of the cable wire into the hole in the
lift rod. Place the threaded fitting into the slot in the
lift bracket, with one hex nut above and one hex
nut and the lock washer below the slot. Tighten the
nuts, adjusting them to eliminate slack in the cable
wire. See figure 24. Refer also to the Service and
Adjustments section on page 20 in this manual.
HINT: For easier assembly of the lift release cable, tilt
the snow thrower forward onto the spiral auger.
13