Craftsman 486.24839 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assemble a shoulder bolt, a 3/8“ lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 3.
Proceed to page 8.
TRACTORS WITH AXLE MOUNTED FRONT
SUSPENSION BRACKETS
•
• Remove the bolt from the hole on each side of the
tractor frame as shown in figure 4.
Attach the R.H. Side Pi ate (marked "R") to the right
side of the tractor frame as shown in figure 5. For the
front hoie use a 3/8" x 1" hex bolt, a 3/8“ lock washer,
a 1/2" flat washer and a 3/8" hex lock nut. Use the flat
washer as a shim between the frame and the side
plate. For the rear hole use a 3/8" x 1" hex bolt, and a
3/8" lock washer. Repeat for the L.H. side.
NOTE: Depending on the tractor model, the bolt
may insert freely into the front hole or it may screw
into the hole. If the hole is not threaded, the bolt
will form threads as it is screwed in.
• Assemble a shoulder bolt, a 3/8" lock washer and a
3/8" hex lock nut to the bottom hole in each side
plate. See figure 6.