Craftsman 113.24181 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
When "WIDTH OF RIP" is 2 in. to 6 in. wide USE THE
PUSH STICK to feed the work.
When WIDTH OF RIP is NARROWER than 2 in., the push
stick CANNOT be used because the guard will interfere ...
USE
the
AUXILIARY
FENCE/WORK
SUPPORT
and
PUSH BLOCK.
Attach auxiliary fence to rip fence with two "C" clamps.
Feed the workpiece by hand until the end is approx. 1 in.
from the front edge of the table. Continue to feed using the
PUSH BLOCK.
When ripping narrow strips that may enter the guard and
strike the baffle, CAREFULLY raise guard only enough to
clear the workpiece. Use Push Block to complete cut
21
Advertising