Troubleshootin, Problem, Cause – Craftsman 580.752010 User Manual

Page 19: Correction

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

[

TROUBLESHOOTIN

I

J

Problem

Cause

Correction

Pump has following problems;

failure to produce pressure,
erratic pressure, chattering, loss
of pressure, low water volume.

1. Low pressure spray tip installed.

2. Water inlet is blocked.

3. Inadequate water supply.

4. Inlet hose is kinked or leaking.

5. Clogged inlet hose strainer.

6. Water supply is over 100°F.

7. High pressure hose is blocked

or leaks.

8. Gun leaks.

9. Spray tip is obstructed.

10. Pump is faulty.

1. Replace spray tip with high

pressure spray tip.

2. Clear inlet.

3. Provide adequate water flow.

4. Straighten inlet hose, patch

leak.

5. Check and clean inlet hose

strainer.

6. Provide cooler water supply.

7. Clear blocks in outlet hose.

8. Replace gun.

9. Clean spray tip.

10. Contact Sears service facility.

Detergent fails to mix with spray.

1

.

Detergent siphoning tube is not

submerged.

Chemical filter is clogged or
cracked.

Dirty in-line filter.

High pressure spray tip
installed.

1. Insert detergent siphoning tube

into detergent.

2. Clean or replace filter/detergent

siphoning tube.

3. See "Check In-Line Filter".

4. Replace spray tip with low

pressure spray tip.

Engine runs good at no-load but
"bogs" when load is added.

Engine speed is too slow.

Move throttle control to FAST
position. If engine still "bogs down",
contact Sears service facility.

Engine will not start; or starts

and runs rough.

1. Low oil level.

2. Dirty air cleaner.

3. Out of gasoline.

4. Stale gasoline.

5. Spark plug wire not connected

to spark plug.

6. Bad spark plug.

7. Water in gasoline.

8. Overchoking.

9. Excessively rich fuel mixture.

10. Intake valve stuck open or

dosed.

11. Engine has lost compression.

1. Fill crankcase to proper level.

2. Clean or replace air cleaner.

3. Fill fuel tank.

4. Drain gas tank; fill with fresh

fuel.

5. Connect wire to spark plug.

6. Replace spark plug.

7. Drain gas tank; fill with fresh

fuel.

8. Open choke fully and crank

engine.

9. Contact Sears service facility.

10. Contact Sears service facility.

11. Contact Sears service facility.

Engine shuts down during

operation.

Out of gasoline.

Fill fuel tank.

Engine lacks power.

Dirty air filter.

Replace air filter.

Engine "hunts" or falters.

Choke is opened too soon.

Move choke to halfway position until

engine runs smoothly.

19

Advertising