Craftsman 315.115033 - Manual (Page 6)

PRODUCT SPECIFICATIONS
Size of Sanding Disc
Size of Poiishing Bonnet
Horsepower
6 inches Rating 120 voits, 60 Hz, AC only, 4.5 amps.
6 inches Spindle Size 1/2 inch 20 TPI
1/2 No Load Speed 1,400/min. & 1650 /min.
OPERATION
A WARNING: Always wear safety goggles or
safety glasses with side shields when operating
your sander/polisher. Failure to do so could
result in dust, shavings, loose particles or foreign
objects being thrown into your eyes, causing
possible serious injury.
KNOW YOUR SANDER/POLISHER
Your sander/polisher is suitable for sanding with
coarse, medium, and fine grit sanding discs. When
used with the polishing bonnet supplied, it can also be
used as a buffer or polisher.
Before attempting to use any tool, familiarize yourself
with all operating features and safety requirements.
A WARNING: The double insulated system is
““ intended to protect the user from shock resulting
from a break in the tool's internal wiring. Observe
all normal safety precautions related to avoiding
electrical shock.
TWO SPEED SWITCH
See Figure 1.
Your sander/polisher is equipped with a two speed
switch trigger located in the rear handle. To turn
ON,
depress switch trigger, to turn OFF, release switch
trigger. For low speed sanding or polishing, depress
switch trigger halfway. For high speed sanding or
polishing depress switch trigger all the way. Be sure
switch trigger is in OFF position before connecting to
power supply source.
A WARNING: Do not allow familiarity with your
tool to make you careless. Remember that a
careless fraction of a second is sufficient to
inflict severe injury.