Craftsman 875.199810 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Owner’s Manual
Model No. 875.199810
through the air hose for 5-10 seconds.
Air Hoses for your Air Tools
Figure 1 illustrates a recommended air
hose hook up.
A 3/8 inch ID air hose is required up to a
length of 25 feet. A 3/8 inch ID hose
longer than 25 feet wiH cause a pressure
drop and may impede performance. If
more length is required, a
'A
inch ID air
hose is recommended. Be sure all hoses
and fittings are the correct size and
correctly secured before using the tool.
Small (horns) shop hard piping:
A piping diagram for a typical home shop
is shown. Some helpful Ups are;
•
Always use hoses and pipes rated for
higher pressure than your system will
encounter.
•
Never use PVC pipes for
compressed air piping systems as
explosion and serious injury may
result.
•
The connection from the compressor
to the initial take-off hard pipe must
ENG-6