Craftsman 1450 Series Engine - Manual (Page 18)

OFF-SEASON STORAG
A
warning
Never store chipper shredder with fuel in tank indoors or in poorly
ventilated areas where fuel fumes may reach an open flame, spark,
or pilot light as on a furnace, water heater, clothes dryer, or gas
appliance.
I
PREPARING THE ENGINE
For engines stored over 30 days:
1. To prevent gum from forming in fuel system or on carburetor
parts, run engine until it stops from lack of fuel or add a gasoline
additive to the gas in the tank. If you use a gas additive, run the
engine for several minutes to circulate the additive through the
carburetor—after which the engine and fuel can be stored up to
six months.
While engine is still warm, change the oil. See Change Engine Oil
in SERVICE AND MAINTENANCE section.
Remove spark plug and pour approximately 1 oz. (30 ml) of clean
engine oil into the cylinder. Pull the recoil starter several times to
distribute the oil, and reinstall the spark plug.
Clean engine of surface debris.
2
.
3.
PREPARING THE CHIPPER SHREDDER
• When storing the chipper shredder in an unventilated or metal
storage shed, care should be taken to rustproof the non-painted
surfaces. Using a light oil or silicone, coat the equipment,
especially any springs, bearings, and cables.
• Remove all dirt from exterior of engine and equipment.
• Follow lubrication recommendations.
• Store equipment in a clean, dry area. Do not store next to
corrosive materials, such as fertilizer. Do not store in an area
where equipment is present that may use a pilot light or has a
component that can create a spark.
18