Safety labels, To avoid serious injury, A dange – Craftsman 1450 Series Engine User Manual
Page 7: Oe.y, Adanger, A danger
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SAFETY LABELS
ADANGER
TO AVOID SERIOUS INJURY:
• Do not operate on uneven ground where unit is
unstable. Do not operate on pavement, gravel or
other hard surfaces since objects can ricochet
and cause injury.
• To avoid a fire hazard, keep leaves, grass, and other
combustible materials away from hot engine and
muffler.
• Keep children and others away from area of
operation.
• Wear approved safety glasses, gloves and ear
protection.
INSTRUCTIONS:
TO RAISE AND LOWER HOPPER
ADANGER
TO AVOID SERIOUS INJURY:
• Read the owner's manual(s) before starting and
using unit.
• Keep all shields and guards in place and securely
attached.
• Keep hands, feet, face, clothing and long hair out of
Shredder Hopper, Chipper Chute and Discharge
Chute while the engine is running. Rotating cutting
blades inside these openings will cause serious
personal injury if contacted. Material being
processed
may bounce back from inlet openings or be thrown
from the discharge chute. Long hair or loose clothing
may be pulled sucked into the inlet openings.
• Do not place branches over 1/2 inch diameter into
the large Shredder Hopper. Branches over 1/2 inch in
diameter should be placed in the Small Chipper
Chute.
• If the chipped shredder jams or becomes clogged,
immediately shut off the engine and wait for all
moving parts to come to a complete stop before
clearing.
• Do not install remove, adjust, or service the
discharge screen or any other part while the engine
is running. Blade contact can occur.
A
0
A DANGE
ROTATING
CUTTING
BLADES.
KEEP HANDS AND FEET OUT
OF OPENINGS WHILE MACHINE
IS RUNNING.
A DANGER
DO NOT OPERATE THIS MACHINE
UNLESS THE CHUTE DEFLECTOR
HAS BEEN PROPERLY INSTALLED.
oe.y
• ROTATING CUTTING BLADES.KEEP HANDS
AND FEET OUT OF OPENING WHILE
MACHINE IS RUNNING.
• DO NOT OPERATE THIS MACHINE UNLESS
THE CHUTE DEFLECTOR HAS BEEN
PROPERLY INSTALLED AND IS SECURED
WITH THE HAND KNOBS.
m
A
WARNING
DO NOT DEPOSIT
MATERIAL LARGER THAN
1/2" DIAMETER IN LARGE
SHREDDER HOPPER.
THIS MAY DAMAGE
MACHINE.