Craftsman 358.792442 - Manual (Page 10)

KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTER ATTACHMENT. Compare the ilfusfrations with your unit to familiarize
yoursalf with the location of various controls and adjustments. Save this manual for
future reference.
Hanger
i
Blade
BLADE
The BLADE is designed for cutting
grass, weeds, and brush up to 1/2 inch
{1 cm) in diameter,
TRIMMER HEAD
The TRIMMER HEAD holds cutting line
and is designed for cutting grass and
light weeds.
BLADE SHIELD
The BLADE SHIELD provides protection
from the spinning blade.
TRIMMER SHIELD
The TRIMMER SHIELD provides protec­
tion from the spinning trimmer head.
OPERATING THE COUPLER
Your powerhead is equipped with a
coupler which enables optional attach­
ments to be installed. The optional at­
tachments are:
Edger............................ 358.792402
Cultivator....................... 358.792410
Blower.......................... 358.792421
^WARNING: Always disconnect
powerhead spark plug before remov­
ing or installing attachments.
REMOVING BRUSHCUTTERAT-
TACHMENT<OR OTHER OPTIONAL
ATTACHMENTS)
CAUTION:
When removing or instal­
ling attachments, place the powerhead
and attachment on a flat surface for
stability.
1. Loosen the coupler by turning the
knob counterclockwise.
Coupler
Lower
Attachment
2
.
Upper Shaft
LOOSEN
TIGHTEN
Press and hold the locking/release
button.
Locking/Release
Button ‘
^
Upper Shaft
/ Coupler!
Lower Attachment
3. While securely holding the upper
shaft, pull the attachment straight
out of the coupler.
10