Craftsman 358.792442 - Manual (Page 9)

NOTE: The dust cup and retaining
washer are iocated on the gearbox shaft
and not in the parts bag. All other fas­
teners mentioned in the following as­
sembly steps are in the parts bag.
1. Remove the retaining washer from
the threaded shaft of ttie gearbox.
Leave the dust cup on the shaft.
2. Install the blade and the retaining
washer over ttie threaded shaft.
3. Make sure the raised part of the re­
taining washer is facing the gearbox
and the raised area fits into the hole
in the center of Uie blade.
4. Slide the blade and retaining
washer onto the shaft of the gear­
box.
5. Place the cupped washer onto the
shaft. Make sure the cupped side
of the washer Is toward the blade.
6. Install the blade nut by threading
onto the shaft counterclockwise.
NOTE: Make sure all parts are in place
as illustrated, and the blade Is sand­
wiched between the dust cup and the
retaining washer. There should be no
space between the blade and ttie dust
cup or the retaining washer.
7. Align hole in dust cup with hole in
side of gearbox by rotating the
blade.
8. Insert a small screwdriver into
aligned holes. This will keep the
shaft from turning while tightening
the blade nut.
9. Tighten blade nut firmly with a
wrench while holding screwdriver
in position.
10. Remove the screwdriver.
11. Turn blade by hand. If the blade
binds against the shield, or ap­
pears to be uneven, the blade is
not centered, and you must rein­
stall.
NOTE: To remove blade, insert screw­
driver into aligned holes. Unthread ttie
nut and remove parts. Be sure to store
parts and Instructions for future use.
Cupped _
Washer