Craftsman 917.292394 - Manual (Page 13)

MUFFLER
Do not operate tiller without muffler. Do not
tamper with exhaust system. Damaged
mufflers or spark arresters could create a
fire hazard. Inspect periodically and
replace if necessary. If your engine is
equipped with a spark arrester screen
assembly, remove every 50 hours for
cleaning and inspection. Replace if
damaged.
SPARK PLUG
Replace spark plugs at the beginning of
each tilling season or after every 50 hours
of use, whichever comes first. Spark plug
type and gap setting are shown in
“PRODUCTSPECIFICATIONS”.
TRANSMISSION
Your transmission is sealed and will not
require lubrication unless serviced.
CLEANING
• Clean engine, wheels, finish, etc. of all
foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with automo­
tive type wax.
We do not recommend using a garden
hose to clean your unit unless the muffler,
air filter and carburetor are covered to
keep water out. Water in engine can result
in a shortened engine life.
SERVICE AND ADJUSTMENTS
^CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come into contact with plug.
TILLER
TO ADJUST HANDLE HEIGHT
Factory assembly has provided lowest
handle height. Select handle height best
suited for your tilling conditions. Handle
height will be different when tiller digs into
soil.
• If a higher handle height is desired,
loosen the four nuts securing handle
panel to engine brackets.
• Slide handle panel to desired location.
• Tighten the four nuts securely.
Engine Brackets
Handle Panel
Nuts (Also 2
on left side
of tiller)
TINE ARRANGEMENT
Your outer tines can be assembled in
several different ways to suit your tilling or
cultivating needs.
^CAUTION: Tines are sharp. Wear
gloves or other protection when handling
tines.
NORMAL TILLING - 24 " PATH
* Assemble holes “A” in tine hubs to holes
“B" in tine shaft.
MID-WIDTH TILLING - 22" PATH
• Assemble holes “A” in tine hubs to
holes “C” in tine shaft.
A,V
13