Craftsman 917.256544 - Manual (Page 23)

5;4r|b..-~iL: Uiii-UJ-i HHR-bb iUib
-js,^ ’ M«bn! iTvio '’Vj... :,“i .diîj
■ il M. '! I, h ' h^uS. It eii'Mf.'r-ii."Nc I ' J ’ ^ f ’ f i ' r ' f ^
iH‘i ; r <-i;t"-’:f h ii li ¡',.") 5--,}i".Mii T!,;c-J|tf’ .' ■:
i’■he 1 i ..- îî i se ■> c-J-''
\ u ■ f * • Î jIh'A V
t r., i!-.: - t'. r. ■ r. I‘* '( .'III-.I l'’^)
' I. . • r 1 . i w f ri' -i" K' hf- 'j '
• “ii! , C'-iiib> [iKl !if>T! >jfMi.Ji!t k~',vi !" 1 i' !* ''V ' fr
h . !. r*'“ ‘i f' n S' I Î- 'nc ih­
» righ-ren !oci<nu!3 securely.
es'Mêr- eifT ? £' i'Ep
. ¡jr^uTeij.
u,ics, ra,s
FIG. 27
TO ADJUST STEERING WHEEL ALIGNMENT
!f steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straightforward, remove steer­
ing wheel and reassemble per instructions in the Assembly
scîction of this rnarsual.
FRONT WHEEL TQE-IN/CAMSER
Thfi front wheel toe-in and camber are not adjustable on
your treictor, !f damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service centsr/deparimenî.
b }' UrNO¥F. TAILLJ Ft.'F
■ boj ,.d:
G ' I j[ .1 'ii,
b m..'- 'Sf,iclufiiingnnc ¡111 /
bed r*-isv.t3( UÉ.” f • -o.rjii s s eg > r* b-i
or |-
t '-po'r fur ■.eo'st.mtG
,n r'r,r Viherî- niy ugncroovhc n rear'A'hei.i f:Lb
. r-o n
' k
iti^' n -^quoi-' fiO'
■ P ".vrlv-îS ~.n'i ‘VC-if fct uriiig iPCj oewj-« I-’ i'!
axle groove.
® Ffepiace axle cover.
TO. START ENGINE WITH A WEAL E-fATTERY
(See Fig. 30)
A
CAISTIOI'I: Leiad-srrid fcatterse-*? gener™
ote erxplosive gases. Keepsparhs, flame
arjcf srsiokin.g №31611.31.3 away from bat­
teries. Aiwaifs iMear eye pretecliori
wEsen around bati
0 rle.s.
If your baltery rs too wo.ak trs start the engine, it should be
recharyod. If "jumper cebims' are usofi for emergency
siailMig. follow Ihio procedure-'
IMFOPTAHT 7GUP TRACTOR iS EUiilPPftP WITH A
12 VOLT NEGATIVE GROUNDER S'f-STEM. THE OTHER
VEiHiCLE MUST ALSO Bff A 12 VOLT NFGATIVE
OnOUNDEO S y 'STEM DO HOT USE YOUR TRACTOR
PATTL-R'Y to . start DTHEFi VEHICLES,
TO ATTACH JUMPER, CABLES -
• Connect each end of the RED cable to the POSITIVE
(+) terminal of each battery, taking care not to short
against chassis,
'
® Connect one end of the BLACK cable to the NE-IGA~
TIVE (-} terminal of fully charged battery.
• Connect the other end of the E-LACK cable to good
CHASSIS GROUND, awayfromfueltankand battery.
TO REMOVE CABLE-3, REVELRSE ORDER -
® BLACK cable first from chassis and then irom the fully
charged battery.
• RED cable test from both batteries.
23