Support long workpieces – Craftsman 315.235380 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
■
Before turning on the saw, perform a dry run of №e
cutting operation just to make sure that rK> problems
will occur when the cut is made.
■
Grasp the saw handle firmly, slide the lock-off lever
back, then squeeze the switch trigger. AHow several
seconds for the blade to reach maximum speed.
■
Slowly lower the blade into and through the work
piece.
See Figures 29 and 30.
■
Release the switch trigger and allow foe saw blade
to stop rotating before raising foe blade out of
workpiece. Wait until the electric brake stops blade
from turning before removing foe workpiece from
miter table.
SUPPORT LONG WORKPIECES
See Figure 31.
Long workpieces need extra supports. Supports
should be placed along the workpiece so it does not
sag. The support should let the workpiece lay flat on
the base of the saw and work table during the cutting
operation. Use the optional work clamp or a C-clamp
to secure the workpiece.
iV WARNING:
To avoid serious personal injury,
always keep your hands outside foe no hands
zone; at least 3 in. from blade. Never perform