Craftsman 137.248830 - Manual (Page 2)

TABLE OF CONTENT
SECTION
Warranty............................................
Product Specifications......................
Power Tool Safety.............................
Table Saw Safety...............................
Electrical Requirements and Safety.
Accessories and Attachments...........
Tools Needed For Assembly.............
Carton Contents................................
PAGE
2
2
3
4
5
6
6
6
SECTION
Know Your Table Saw.........
Assembly and Adjustments.
Operation.............................
Maintenance........................
Troubleshooting Guide........
Parts List..............................
Push Stick Pattern................
WARRANT
PAGE
8
9
16
20
21
22
30
FULL ONE YEAR WARRANTY
If this product fails due to a defect in material or workmanship within one year from the date of purchase, Sears will
at its option repair or replace it free of charge.
Contact a Sears Service Centre for replacement.
If this product is used for commercial or rental purposes, this warranty applies only for 90 days from the date of
purchase.
This warranty is in addition to any statutory warranty.
Sears, Roebuck & Co., Dept. 817 WA, Hoffman Estates, IL 60179
A
WARNING
Some dust created by power sanding, sawing, grinding, driiling and other construction activities contains
chemicais known to the state of Caiifornia to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicais are;
• Lead from lead-based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment such as dust
masks that are specially designed to filter out microscopic particles.
I
PRODUCT SPECIFICATION
MOTOR SAW
HP (Maximum developed).... 3.0 Table Size............................. 26-7/64” X 19-1/2”
Type................... Universal Table Extensions.................. 3 - Left,Right,Rear
Amps.................. 15 Extension Rip Capacity........ 24” Right and Left
Voltage............... 120 Blade Size............................. 10” Diameter
Hz...................... 60 Arbor Size.............................. 5/8” Diameter
RPM (no load}.... 5000 Rip Fence.............................. Self Aligning
Overload Protection............... YES Miter Gauge........................... T-Slotted
Maximum Cut Depth @ 90°.. 3”
Maximum Cut Depth @ 45°.. 2-1/2”
Maximum Dado Cut Width... 1/2"
A
WARNING Net Weight........................... 65 LBS
To avoid electrical hazards, fire hazards or damage to the table saw, use proper circuit protection.
This table saw Is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /15 Ampere
time delay fuse or circuit breaker. To avoid shock or fire, replace power cord immediately if it is worn, cut or
damaged in any way.
Before using your table saw. It Is critical that you read and understand these safety rules. Failure to follow these
rules could result In serious Injury to you or damage to the table saw.
2