Craftsman 315.271270 - Manual (Page 6)

FEATURES
KNOW YOUR HAMMER DRILL
See Figure 1.
Before attempting to use your hammer drill, familiarize
yourself with all operating features and safety
requirements.
WARNING: Carefully read through this entire owner's
manual before using your new hammer drill. Pay dose ..
attention to the Rules For Safe Operation, Warnings
and Cautions. If you use your hammer drill properly and
only for what it is intended, you wilt enjoy years of sate,
reliable service.
WARNING; Do not allow familiarity with your hammer
drill to make you careless. Remember that a careless
fraction of a second is sufficient to inflict severe injury.
KEYLESS CHUCK
Your hammer drill has a keyless chuck that allows you to
hand tighten or release drill bit in the chuck jaws.
SWITCH
To turn your hammer drill ON, depress the switch trigger.
Release switch trigger to turn your hammer drill OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
tool when not in use.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
TWO SPEED GEAR TRAIN
Your hammer drill has a two speed gear train designed for
drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed.
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Your hammer drill has a forward/reverse selector located
above the switch trigger.
WRIST STRAP
A wrist strap is provided to reduce the chances of dropping
your hammer drill. Place one hand through the wrist strap
when carrying tool.
BIT STORAGE
When not in use, bits provided with your hammer drill can
be placed in the storage area located on the top of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top and end of the motor housing.
AUXILIARY HANDLE
An auxiliary handle is packed with your hammer drill for
ease of operation and to help prevent loss of control.
DEPTH GAGE ROD
A depth gage rod has been packed with your hammer drill
to assist you in controlling the depth of drilled holes.
WARNING: If any parts are missing, do not operate
your hammer drill until the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
PRODUCT SPECIFICATIONS:
HAMMER DRILL 315.271270
Chuck 1/2 in. Keyless
Motor DC Motor 18 Volt
Gear Train Two Speed
Switch Variable Speed
No Load Speed 0-400 RPM (Low)
0-1400 RPM (High)
Hammer Speed 0-6,400 (Low)
0-22,400 (High)
Clutch 24 Positions
Maximum Torque 500 in ./lbs.
CHARGER ITEM NO. a-11040
Input 120 V, 60 Hz, AC only
Charging Voltage 9.6 - 24 Volt
Charge Rate 1 Hour
BATTERY PACK ITEM NO. 9-11034