Auxiliary handle, To attach battery pack to drill, To remove battery pack from drill – Craftsman 315.271270 User Manual
Page 9: Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
AUXILIARY HANDLE
See Figure 4.
An auxiliary handle is packed with your drill for ease of
operation and to help prevent loss of control. The handle
can be rotated 360° and it can also be mounted on
opposite side for left hand use.
Note:
For convenience and ease of starting threads, the
hex nut has been trapped inside the molded slot in the
auxiliary handle.
TO INSTALL:
■
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 13.
■
Loosen wing screw enough to make ring of handle
large enough to fit over chuck.
■
Place ring of handle over the chuck and mode selec
tor.
Note:
Handle fits in a groove behind torque
adjusting ring.
■
Rotate handle to desired angle.
■
Tighten wing screw securely.
Note;
If wing screw and wear plate is removed from
auxiliary handle, when reassembling, the markings on
the wear plate must be positioned as shown in Figure
4. This prevents the depth gage rod from slipping.
See Figure 4.
WING SCREW
TO
TIGHTEN
TORUE
ADJUSTING
RING GROOVE
RAISED RIB
AUXILIARY
HANDLE
MARKINGS ON
BACKSIDE
OF WEAR PLATE
Fig. 4
To prevent possible loss of control, auxiliary handle
should be checked periodically for tightness.
Do not
operate hammer drill with auxiliary handle loose.
TO ATTACH BATTERY PACK TO DRILL
See Figure 5.
Note:
Battery pack is shipped in a low charge condition.
Therefore, it must be charged prior to use. Refer to page 11,
"CHARGING BATTERY PACK"
for charging instructions.
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 13.
Align raised ribs on battery pack with grooves on
bottom of drill, then attach battery pack to drill as
shown in Figure 5,
Make sure latch on battery pack snaps in place and
battery pack is secured to drill before beginning
operation.
RAISED RIBS
LATCH
CAUTION:
When attaching battery pack to your
drill, be sure raised ribs and grooves align properly
and latch snaps in place properly. Improper assembly
can cause damage to drill and battery pack.
TO REMOVE BATTERY PACK FROM DRILL
See Figure 6.
■
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 13.
■
Depress latch located on front of battery pack (1) to
release battery pack.
■
Pull forward on battery pack (2) to remove from drill.
DEPRESS LATCH TO
RELEASE BAHERY PACK
PULL
FORWARD
TO REMOVE
BAHERY PACK
Fig. 6