Craftsman 315.228110 - Manual (Page 17)

ASSEMBLY
each leg with the bolts pointing up. Cap with the
remaining flat washers and hex nuts but do not
tighten,
■ Move the leg set to desired location. Adjust the
leveling feet with a 12 mm wrench, then tighten the
top hex nut.
ASSEMBLING STORAGE BRACKETS
See Figure 8.
■ Take storage brackets from loose parts.
■ Take the following hardware from the leg stand
hardware bag:
4 screws (1/4-20 x 1/2 in. Pan Hd.)
4 hex nuts (1/4-20}
4 washers (1/4 in.)
■ Secure storage brackets to upper braces of leg
stand as shown in figures 8 and 9.
Note: If you mount the saw base on a bench instead
of the legs, go to the Assembly of Rails, Tables,
Fences procedure. The bench surface must
have an opening for sawdust to fall through, as
large as the opening in the bottom of the saw
base. A height of 36 in. from the top of the saw
table to the floor is recommended.
MOUNTING THE LEG STAND ON THE TABLE
SAW BASE
See Figure 10.
■ Take the following from a small hardware bag;
4 hex bolts (1/4-20
X
3/4
in.)
4 hex nuts (1/4-20)
8 flat washers (1/4-20 in.)
Note: This hardware was in the bag with hardware for
assembling the leg stand and leveling feet.
■ Place the saw table upside down on a smooth
surface, such as cardboard, on the floor.
WARNING: Do not lift the saw without help.
The saw base weighs approximately 75 lbs. Hold
it close to your body. Keep your knees bent and
lift with your legs, not your back. Ignoring these
precautions can result in back injury.
■ Place the leg stand on the table saw base. Align
the holes in the table with the holes in the end
braces.
■ Place a flat washer on a bolt and insert through
hole. Add a flat washer and a hex nut. Hand
tighten.
See Figure 10.
■ Repeat for three remaining holes. Tighten all
hardware with a 12 mm wrench. You may find it
helpful to use one wrench to hold the head of the
bolt and one to tighten the hex nut.
17 CIlflFTlHIlN* TABLE SAW 315.228110