Craftsman 358.795580 - Manual (Page 4)

• store unit so line limiter blade cannot
accidentally cause injury. The unit can
be hung by the tube.
• Store unit out of reach of children.
SAFETY NOTICE: Exposure to vibra­
tions through prolonged use of gaso­
line powered hand tools could cause
blood vessel or nerve damage In the
fingers, hands, and joints of people
prone to circulation disorders or ab­
normal swellings. Prolonged use in
cold weather has been linked to blood
vessel damage in otherwise healthy
people. If symptoms occur such as
numbness, pain, loss of strength,
change in skin color or texture, or loss
of feeling in the fingers, hands, or
joints, discontinue the use of this tool
and seek medical attention. An anti­
vibration system does not guarantee
the avoidance of these problems. Us­
ers who operate power tools on a con­
tinual and regular basis must monitor
closely their physical condition and
the condition of this tool.
SPECIAL NOTICE: This unit is
equipped with a temperature limiting
muffler and spark arresting screen
which meets the requirements of Cali­
fornia Codes 4442 and 4443. All U.S.
forest land and the states of California,
Idaho, Maine, Minnesota, New Jersey,
Oregon, and Washington require by
law that many internal combustion en­
gines be equipped with a spark arrest­
ing screen. If you operate in a locale
where such regulations exist, you are
legally responsible for maintaining the
operating condition of these parts.
Failure to do so is a violation of the
law. For normal homeowner use, the
muffler and spark arresting screen will
not require any service. After 50
hours of use, we recommend that your
muffler be serviced or replaced by a
Sears Service Center.
ASSEMBLY
CARTON CONTENTS
Check carton contents against the fol­
lowing list.
Model 358.795580
• Trimmer
• Shield
• Wing Nut (screwed onto shield)
• Container of line
• Container of oil
Examine parts for damage. Do not
use damaged parts.
NOTE: If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
It is normal for the fuel filter to rattle in
the empty fuel tank.
Finding fuel or oil residue on muffler is
normal due to carburetor adjustments
and testing done by the manufacturer.
ASSEMBLY
WARNING: If received as­
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
ADJUSTING THE HANDLE
WARNING: When adjusting the
handle, be sure it remains between
the trigger and the safety decal.
1. Loosen wing nut on handle.
2. Rotate the handle on the tube to an
upright position; retighten wing nut.
ATTACHING SHIELD
A WARN IN G : The sh ield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under­
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP­
ERATION section.
1. Remove wing nut from shield.
2. Insert bracket Into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto bolt.