Setting up lift mounting hardware – Craftsman 610.24610 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting up Lift Mounting Hardware
Tractor Lift can be used out of the box on all Craftsman tractors with bumpers or brush guards. For tractors without bumper or brush guard,
Tractor Lift mounting hardware is provided. Follow the steps below:
Insert bolt ( 29 ) through inside front hole of frame, through
tractor bracket ( 7 ) and secure with nyloc nut ( 27 ).
Add flat washer ( 24 ) under head of bolt removed in earlier
step and reinsert through tractor mounting bar and tighten.
For LT1000 & LT2000 series tractors, use self-thread bolts
( 28 ) in place of bolt ( 29 ) and nut ( 27 ).
Slide lifting bar ( 6 ) through cut-out in tractor brackets.
Pin lifting bar in place with one hairpin cotter ( 26 ) on each
side, inside of tractor brackets ( 7 ).
Secure in place with flat washer ( 32 ) and hex nut ( 31 ).
FOR MISSING PARTS, Call 1-800-652-2321, Monday - Friday, 8 a.m. - 5 p.m. E.S.T.
Page 5.