Troubleshooting – Craftsman 580.762200 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

PROBLEM

CAUSE

CORRECTION

Pump has following problems:

failure to produce pressure, or

1. Nozzle in low pressure mode.

1. Pull nozzle backward for high

pressure mode.

erratic pressure, chattering, toss of

2. Water inlet is blocked.

2. Clear inlet

preraure, low water volume.

3. Inadequate water supply

3. Provide adequate water flow at

least 2.2 gpm.

4. Inlet hose is kinked or leaidng

4. Straighten inlet hose, patch teak.

5. Clogged water inlet screen.

5. Replace/clean water inlet screen.

6. Water supply fe over 140°F.

6. Provide cooler water supply.

7. Outlet hose is blocked.

7. Clear blocks in outlet hose.

8. Outlet hose leaks.

8. Replace outlet hose If leaking.

9. Gun leaks.

9. Replace o-ring or gun if necessary.

10. Nozzle is obstructed.

10. Clear nozzle.

11. Pump is faulty.

11. Contact Sears Service Departnent.

Determent fails to mix with,

spray^

1. Detergent line Is not submerged,

in detergent spray

1. Insert chemical line into detergent.

2. Chemical filter is clogged.

2. Clean or replace filter/detergent

line.

3. Nozzle is in high pressure mode.

3. Push nozzle forward for

low pressure mode.

Engine runs good when not spraying

but dies when you begin to spray.

Engine speed is too slow.

Contact Sears Service Department.

Engine will not start; or starts

1. Dirty air cleaner

1. Clean or replace air cleaner.

and runs rough

2. Out of gasoline.

2. Fill fuel tank.

3. Stale gasoline.

3. Drain gas tank; fill with fresh fuel.

4, Spark plug wire not connected

to spark plug.

4. Connect wire to ^aik plug.

5. Bad spark plug.

5. Replace spark plug.

6. Water in gasoline.

6. Drain gas tank; fill with fresh ftiel.

7. OverchoWng or flooded

7. Set engine throttle control lever to

fast position, choke in run position.

8. Excessively rich fuel mixture.

8. Contact Sears Service Departaent.

9. Intake valve stuck open or closed.

9. Contact Sears Service Department.

10. Engine has lost compression.

10. Contact Seara Service Department.

Engine shuts down during

1. Out of gasoline.

1. Fill fuel tank-

operation

2. Air filter dirty

2. Replace Air filter.

Engine lacks power.

Dirty air filter.

Replace air filter.

16

Advertising