Craftsman 919.762350 - Manual (Page 6)

Tools Required for Assembly
Adjustable wrench
Alien wrench 5mm (included)
Remove Pressure Washer from Carton
• Open box from the top. Locate and remove from
box, thè parts box, which includes gun, handle,
wand,oil, knobs and J bolts. Next remove the parts
bag and the handle.
• Cut carton along dotted lines.
• Remove all carton inserts.
• Roll unit through opening in Carton.
NOTE: The hose is located at the bottom of the box.
Preparing the Pressure Washer for First Use
Note: Included with your pressure washer is a
video cassette tape on how to prepare your unit
for operation. It Is recommended you view this
tape before performing the next steps.
1. • Insert handle onto frame.
• Slide J bolts Into frame.
• Tighten knobs turning in clockwise direction.
3. • Mount the rubber isolator to the frame. To mount
isolator place threaded end of bolt through the
washer. Next with washer on bolt place threaded
end of bolt through the larger hole in bottom of the
rubber isolator. Place threaded portion of bolt
through the same hole location the wood plank
was mounted to on the pressure washer. Next
place the tee nut over the threaded portion of the
bolt and use the alien wrench provided to tighten
isolator to the frame.
PRESSURE
WASHER
FRAME
\
TEE NUT
I
T
— ISOLATOR
WASHER—<S>
A—BOLT
4. • Connect wand extension to gun. To tighten, turn
knob in clockwise direction. Hand tighten.
5. • Remove tie wrap off of high pressure hose.
Unwind high pressure hose and attach the
threaded end to the gun.
2. • Using an adjustable wrench, remove nut from bolt
that attaches board to frame. Remove wood plank
from the frame of the imlt. Discard bolt and board.
6. • Connect high pressure hose to outlet on pressure
washer and hand tighten firmly. Connect
chemical pickup hose to hose barb on pump.
CHEMICAL
HOSE
HIGH
PRESSURE
HOSE
NOTE: Always keep hose away from engine muffler.