Canon iR 2018 - Manual (Page 5)

7 8
Pr
ef
ac
e
Co
py
in
g
Fu
nc
tio
ns
Fa
cs
im
ile
Fu
nc
tio
ns
O
th
er
U
se
fu
l
Fe
at
ur
es
The Control Panel
(Facsimile Control Panel)
04 01 02 03
08 05 06 07
12 09 10 11
16 13 14 15
20 17
21~40 41~60
18 19
Hook
R Direct TX Stamp
Coded Dial
OK
Delayed TX
Redial/Pause Address Book
1 2 3
4 55 6
7 8 9
0 #
ID C
The Facsimile Control Panel is attached only if the optional Super G3 FAX Board and Fax Panel-B1 are installed.
For more information on using the Fax function, see the Facsimile Guide.
[Fax] Key
Press to switch to the Fax mode.
One-Touch Speed Dial Keys
Press to use one-touch speed
dialing. (Pre-registered frequently
used numbers.)
The Control Panel (Facsimile Control Panel)
[Delayed TX] Key
Press to set Delayed TX.
[R] Key
Press to dial an outside line access
number or an extension number
when the unit is connected through
a switchboard (PBX).
[Address Book] Key
Press to search for names or fax
numbers registered for speed dialing,
and then use the number for dialing.
[Coded Dial] Key
Press to perform coded speed dialing.
[Direct TX] Key
Press to set Direct TX. [Stamp] Key
Press to apply a stamp on the front
side of originals after they have been
scanned, so that you can determine
whether a document was scanned
and send.
[Hook] Key
Press to activate or deactivate the
telephone line. This is necessary for
dialing a fax information service. [Redial/Pause] Key
Redial the three most recent
destinations that was dialed
manually using the numeric keys.
Press to insert a pause between
digits or after the entire fax number.
[Tone] Key
Press to switch temporarily to tone
dialing when connected through a
rotary pulse line. This enables you
to access information services that
only accept tone dialing.