How to use your lawn mower engine speed control – Craftsman 917.387402 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The operation of any iawn mower can result in
foreign objects thrown into the eyes, which can
result in severe eye damage. Always wear
safety glasses or eye shields while operating
your lawn mower or performing any adjust
ments or repairs. We recommend a wide
vision safety mask over spectacles or standard
safety glasses.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
ACAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk of
blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped witti an
operator presence control bar which
requires the curator to be positioned
behind the lawn mower haridle to start and
operate the lawn mower.
TO ADJUST CUTTING HEIGHT
• Raise wheels for low cut and lower wheels
for high cut.
• Adjust cutting height to suit your require
ments. Medium position is best for most
lawns.
• To change cutting height, squeeze adjuster
lever toward wheel. Move wheel up or down
to suit your requiremer^. Be sure all wheels
are in the same setting.
NOTE:
Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
Lower Wheels for High Cut
TO ATTACH GRASS CATCHER
• Close the flip lid. Rip lid must be closed
while operating lawn mower.
• Ut the rear door on the mower housing and
place the grass catcher frame onto the
formed tabs on tiie rear door hinge bracket
• The grass catcher is secured to ^ lawn
mower housing when the rear door is
lowered onto the grass catcher frame.
ACAUTION:
Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear door
removed or propped open.
Hinge
bracket
Rear door
Grass cateher
Formed
tabs
TO EMPTY GRASS CATCHER
• To remove grass cateher, release operator
presence control bar to stop engine.
• Lift up rear door and remove the grass
cateher by the handle.
NOTE:
Do not drag the bag when emptying;