Tractor, To remove mower {see fig. 18), To level mower housing – Craftsman 917.258911 User Manual

Page 21: Service and adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SERVICE AND ADJUSTMENTS

A

CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

Depress clutch/brake pedal fully and set parking brake.

Place motion control lever in neutral (N) position.

» Place attachment clutch in "DISENGAGED” position.
® Turn Ignition key “OFF” and remove key.

Make sure the blades and all moving parts have completely stopped.

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug-____________________________________________________________________________

TRACTOR

TO REMOVE MOWER {See Fig. 18)

Place attachment clutch in "DISENGAGED" position,

Turn height adjustment knob to lowest setting.

Lower mower to its lowest position.

Remove retainer spring holding anti-swaybarto chas­

sis bracket and disengage anti-swaybar from bracket.

Remove retainer springs from suspension arms at
deck and disengage arms from deck.

Raise attachment lift to its highest position.

Remove two retainer springs from each front link and

remove links.

Slide mower forward and remove belt from electric
clutch pulley.

Slide mower out from under right side of tractor.

IMPORTANT:

IF AN ATTACHMENT OTHER THAN THE

MOWER DECK IS TO BE MOUNTED ON THE TRACTOR,
REMOVE THE FRONT LINKS.

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or

driveway.. Make sure tires are properly inflated (See
"PRODUCT SPECIFICATIONS" on page 3 of this manual).
If fires are over or underlnflated, you will not properly adjust

your mower,

SIDE-TO-SIDE ADJUSTMENT (See Figs. 18 and 19)

Raise mower to its highest position.

» Measure height from bottom of deck curl to ground

level at front corners of mower. Distance “A" on both

sides of mower should be the same.

If adjustment is necessary, make adjustment on one

side of mower only.

To raise one side of mower, tighten lift link adjustment

nut on that side.

To lower one side of mower, loosen lift link adjustment

nut on that side.

NOTE: Each half turn of adjustment nut will change mower
height about 3/16“.

Recheck measurements after adjusting.

21

Advertising