Craftsman 358.794772 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

THROTTLE POSITION LEVER
The THROTTLE POSITION LEVER is de­

signed to allow setting engine speed
during blower use only. To avoid caus­
ing damage to the unit, DO NOT at­

tempt to use the throttle position lever

during vacuum use.

PRIMER BULB

The PRIMER BULB removes air from
the carburetor and fuel lines and fills
them with fuel. This allows you to start
the engine with fewer pulls on the

starter rope. Activate primer bulb by
pressing it and allowing it to return to
its original position.

START LEVER

The START LEVER helps to supply fuel
to the engine to aid in starting. Activate
the starting system by moving the start

lever to the START position. DO NOT

squeeze the throttle trigger until the
engine has started and runs. After the
engine starts, allow the engine to
warm-up 10-15 seconds, then fully
squeeze the throttle trigger to deacti­
vate the starting system (start lever re­

turns to RUN position).

OPERATING TIPS
• While vacuuming or blowing debris,

hold the unit with the muffler side fac­
ing away from your body and clothes

(see OPERATING POSITION below).

• To reduce the risk of hearing loss

associated with sound level(s), hear­
ing protection is required,

• To reduce the risk of injury associated

with contacting rotating parts, stop the

engine before installing or removing
attachments. Do not operate without
guard(s) in place.

• Operate power equipment only at rea­

sonable hours-not early in the morn­
ing or iate at night when people might
be disturbed. Comply with times listed
in local ordinances. Usual recommen­
dations are 9:00 a.m. to 5:00 p.m.,

Monday though Saturday,

• To reduce noise levels, limit the num­

ber of pieces of equipment used at
any one time,

• To reduce noise levels, operate pow­

er blowers at the lowest possible

throttle speed to do the job.

• Use rakes and brooms to loosen

debris before blowing.

• In dusty conditions, slightly dampen

surfaces or use a mister attachment

when water is available.

• Conserve water by using power blow­

ers instead of hoses for many lawn
and garden applications, including
areas such as gutters, screens, patios,
grills, porches, and gardens.

• Watch out for children, pets, open

windows, or freshly washed cars.

Blow debris away safely,

• Use the full blower nozzle extension

so the air stream can work close to

the ground.

• After using blowers and other equip­

ment, CLEAN UPl Dispose of debris
in trash receptacles.

OPERATING POSITION

BEFORE STARTING ENGINE

^WARNING:

Be sure to read the

fuel information in the safety rules

before you begin. If you do not
understand the safety rules, do not

attempt to fuel your unit. Cali

1 -800-235-5878.

FUELING ENGINE

^WARNING: Remove fuel cap

slowly when refueling.

This engine is certified to operate on un­

leaded gasoline. Before operation, gaso­
line must be mixed with a good quality

synthetic 2-cycle air-cooled engine oil.
Vife recommend Craftsman brand syn­

thetic oil. Mix gasoline and oil at a ratio

of 40:1. A 40:1 ratio is obtained by mix­

ing 3.2 ounces of oil with 1 gallon of un­

Advertising