Craftsman 919.670280 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

^------- w.

LI i(,ti 11^1 wi 14 Mi^ziManui; OdM

attract moisture which leads to separation and forma­

tion of acids during storage. Acidic gas can damage
the fuel system of an engine while in storage. To avoid
engine problems, the fuel system should be emptied

before storage of 30 days or longer. Never use engine

or carburetor cleaner products in the fuel tank or

permanent damage may occur.

Engine Preparation

First add a fuel stabilizer to the fuel tank.

Run pressure washer for a full 5 minutes to allow

fuel stabilizer to enter the fuel system.

Next shut off engine and disconnect the water

supply.

Disconnect the spark plug wire and remove the

spark plug.

Add one teaspoon of oil through the spark plug
hole.

Place rag over spark plug hole and pull the recoil a

few times to lubricate the combustion chamber.

Replace the spark plug, but do not connect the
spark plug wire.

This pressure washer should be stored in such a way
to protect it from freezing. Do not store this unit
outdoors or in an area where temperatures will fall

below 32® F. This can cause extensive damage to this

unit.

NOTE: Antifreeze needs to be added to pump if
expecting freezing temperatures or storing for longer

than 3 months.

Add antifreeze according to steps below;

Be sure engine switch is in “OFF” position and
spark plug wire has been removed from spark
plug.

Pull the trigger on the spray gun to release the
pressure in the high pressure hose. Detach high
pressure hose and garden hose from the unit.

Pull the recoil on the engine 4 to 6 times to dis­

charge remaining water in pump.

Tip the unit on the end with the water inlet fitting

pointing upward.

If unit will be stored where temperatures fall below

32°F, pour approximately 1/4 cup of non-toxic R.V.
antifreeze down the fitting where the water hose
attaches to the pump.

Set unit upright and pull starter handle on engine 4
to 6 times to circulate antifreeze in pump until
antifreeze is discharged from the pump.

15-ENG

020S90 Rev. 0

Advertising