Craftsman 104.79212 - Manual (Page 3)

SAFE OPERATION RULES
' Never start or run the unit inside a closed room or build­
ing. Breathing exhaust fumes can be fatal. Operate this
unit only in a well ventilated outdoor area.
• Wear safety glasses or goggles that meet ANSI Z87.1
standards and are marked as such. Wear ear/hearing
protection when operating this unit. Wear a face or dust
mask if the operation is dusty.
• Wear heavy long pants, boots, gloves and a long sleeve
shirt. Do not wear loose clothing, jewelry, short pants,
sandals or go barefoot. Secure hair above shoulder
level.
• The cutting attachment shield must always be in place
while operating the unit as a trimmer. Do not operate
unit without proper line installed.
• This unit has a clutch. The cutting attachment remains
stationary when the engine is idling. If it does not, have
the unit adjusted by a Sears or other qualified service
dealer.
• Adjust the handle to your size in order to provide the
best grip.
• Be sure the cutting attachment is not in contact with
anything before starting the unit.
• Use the unit only in daylight or good artificial light.
• Avoid accidental starting. Be in the starting position
whenever pulling the starter rope. The operator and
unit must be in a stable position while starting. Refer to
Starting/Stopping Instructions (p.10).
• Only use this tool for its intended purpose.
• Do not overreach. Always keep proper footing and bal -
ance.
• Always hold the unit with both hands when operating.
Keep a firm grip on both handles or grips.
• Keep hands, face, and feet at a distance from all moving
parts. Do not touch or try to stop the cutting attachment
when it rotates.
• Do not touch the engine, gear housing or muffler. These
parts get extremely hot from operation, even after the
unit is turned off.
WARNING:
The engine exhaust from this product
contains chemicals known to the state of
California to cause cancer, birth defects
or other reproductive harm.
• Do not operate the engine faster than the speed needed
to cut, trim or edge. Do not run the engine at high speed
when not cutting.
• Always stop the engine when cutting is delayed or when
walking from one cutting location to another.
• If you strike or become entangled with a foreign object,
stop the engine immediately and check for damage. Do
not operate before repairing damage. Do not operate
the unit with loose or damaged parts. Stop the unit,
switch the engine to off, and disconnect the spark plug
for maintenance or repair.
• Use only identical replacement parts and accesories
designed for this line trimmer. Use of any other
parts or accessories could lead to serious injury
to the user, or damage to the unit, and void your
warranty
• Keep unit clean of vegetation and other materials. They
may become lodged between the cutting attachment
and shield.
• To reduce fire hazard, replace a faulty muffler and spark
arrestor. Keep the engine and muffler free from grass,
leaves, excessive grease or carbon buildup.
OTHER SAFETY WARNINGS
• Never store a unit with propane canister attached inside
a building where vapor may reach an open flame or
spark.
• Allow the engine to cool before storing or transporting.
Be sure to secure the unit while transporting.
• Store the unit in a dry area, locked up or up high to
prevent unauthorized use or damage, out of the reach
of children.
• Never douse or squirt the unit with water or any other
liquid. Keep handles dry, clean and free from debris.
Clean after each use, see Cleaning and Storage instruc­
tions. (p.19)
• Keep these instructions. Refer to them often and use
them to instruct other users. If you loan someone this
unit, also loan them these instructions.
SAVE THESE INSTRUCTIONS