Craftsman 104.79212 - Manual (Page 5)

TOOL KIT
Your unit is provided with a too! kit (Fig.l). This too! kit
consists of the following:
4 mm Allen Wrench
INSTALLING CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed. Use only the
instructions that apply to the type of shaft and shield
that your unit is equipped with.
FOR CURVED SHAFT TRIMMERS
Place the cutting attachment shield and spacer against
tube as shown in (Fig.2). Use the 2 screws provided
to clamp the cap and shield onto the tube. Tighten the
screws evenly. Make sure the shield does not touch
any rotating parts.
FOR STRAIGHT SHAFT TRIMMERS
Place the cutting attachment shield onto the shaft
mount. Install using provided hardware in the sequence
INSTALLING THE UPPER HANDLE AND SAFETY BAR
1. Locate the 4 screws included in the tool kit.
2. Assemble the upper handle, safety bar and 4 attaching
screws as shown in (Fig.4). Position the handle parts
evenly over the rubber sleeve on shaft. Do not com­
pletely tighten.
3. While holding the unit in the operating position (Fig.
14), position the upper handle to the location that pro­
vides you the best grip.
4. Tighten the clamp screws evenly, until the upper handle
is secure.
WARNING:
To prevent serious injury, never operate the
trimmer without the cutting attachment
in place.