Craftsman 127.28876 - Manual (Page 20)

PRE-^OPERATION CHECK LIST
PRE-OPERATION CHECK LIST
(OPERATOR’S RESPONSIBILITY)
Review and follow all safety rules and safety
decal instructions.
Check that all safety decals are installed and in
good condition. Replace if damaged.
Check to make sure all shields and guards
are properly installed and in good condition.
Be sure that either the discharge shield or
complete vacuum attachment is installed.
Check that all hardware is properly installed,
and secured.
Check that equipment is properly and securely
attached to power unit.
Check to be sure engine is free of dirt and
debris. Pay particular attention to the cooling
fins, governor parts and muffler. Clean air
intake screen. Check air cleaner; service if
necessary.
Never allow riders.
Inspect area and remove stones, branches or
other hard objects that might be thrown,
causing injury or damage.
Clean area around oil fill dipstick. Remove
dipstick and check to be sure oil is in operating
range (between marks on dipstick). Add oil if
necessary but
Do Not Overfill. Install dipstick
assembly firmly until cap bottoms out on tube.
Dipstick assembly must always be secured into
fiil tube when engine is running.
Check all lubrication points and grease as
instructed in manual.
Check hydrostatic fluid level. Check to be sure
cooling fins on hydrostat are clean.
Perform a functional check of the safety
interlock system each time you operate the
unit.
18