Problem cause correction will not start 1, Hard to start 1, Loss of power 1 – Craftsman 917.299210 User Manual

Page 18: Engine 1, Overheats 2

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center

PROBLEM

CAUSE

CORRECTION

Will not start

1

Out of fuel.

1

Fill fuel tank.

2

Fuel valve "OFF"

2

Turn fuel valve to the "ON" position.

3

Engine Switch "OFF"

3

Turn engine switch to the "ON" position.

4

Engine not

“CHOKED”

properly.

4

See “TO START ENGINE” in Operation
section.

5

Engine flooded.

5

Wait several minutes before attempting
to start.

6

Bad spark plug or improper gap.

6

Replace spark plug or adjust gap.

7

Dirty air filter.

7

Clean/replace air filter.

8

Water in fuel.

8

Empty fuel tank and carburetor, refill

tank with fresh gasoline.

Hard to start

1

Throttle control not set properly.

1

See “To Start Engine” in Operations
section.

2

Dirty air filter.

2

Clean/replace air filter.

3

Bad spark plug or improper gap.

3

Replace spark plug or adjust gap.

4

Stale or dirty fuel.

4

Empty fuel tank and refill tank with

fresh, clean gasoline.

5

Loose spark plug wire.

5

Make sure spark plug wire is seated
properly.

Loss of power 1

Engine is overloaded

1

Set depth stake and wheels for
shallower tilling.

2

Dirty air cleaner

2

Clean/replace air filter.

3

Low oil level/dirty oil.

3

Check oil level/change oil.

4

Faulty spark plug.

4

Clean and regap or change spark plug.

5

Oil in fuel

5

Empty and clean fuel tank and refill,
and clean carburetor.

6

Stale or dirty fuel.

6

Empty fuel tank and refill tank with

fresh, clean gasoline.

7

Water in fuel.

7

Empty fuel tank and carburetor, refill

tank with fresh gasoline.

8

Clogged fuel tank.

8

Remove fuel tank and clean.

9

Spark plug wire loose.

9

Connect and tighten spark plug wire.

10

Dirty engine air screen.

10

Clean engine air screen.

11

Dirty/clogged muffler.

11

Clean/replace muffler.

12

Poor Compression

12

Contact a Sears or other qualified
service center.

Engine

1

Low oil level/dirty oil.

1

Check oil level/change oil.

overheats

2

Dirty engine air screen.

2

Clean engine air screen.

3

Dirty engine.

3

Clean cylinder fins, airscreen, muffler
area

4

Partially plugged muffler

4

Remove and clean muffler.

18

Advertising