Asseivibly, Tools required for assembly – Craftsman 536.886141 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1- Screw, 5/16-18 X 2 In.
3 - Carriage Bolts, 5/16-18x1.00 In.
Parts packed separately in carton (not shown full size)
1 - Snow Chute Assembly
2 - Ignition Keys
(Attached to engine in plastic bag)
1 - container 5W30 oil
1 - Crank Assembly
ASSEIVIBLY
A
k
CAUTION:
Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1 - Knife to cut carton and plastic ties
2 ' 1/2 inch wrenches (or adjustable
wrenches)
2- 9/16 inch wrenches (or adjustable
wrenches)
2 - 3/4 Inch wrenches (or adjustable
wrenches)
1 - Pliers (to spread cotter pin)
1 - Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator’s position behind the unit.
Auger drive lever
Shifter,
lever
Traction drive lever
/Clutch cable
■Crank assembly
Chute deflector
Height
adjust
skids