Service and maintenanc – Craftsman 247.889980 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND MAINTENANC
I
J
Remove the screw and flange nut which secures the belt keeper
rod to the left side of the mower’s frame. See Figure 24.
13. Pull the click pin out and unhook the drive spring cable from the
idler arm assembly. See Figure 26.
around the mower’s engine pulley.
Looking at the cutting deck from the left side, locate and carefully
remove the hairpin clips that secure the deck supports on the rear
left side and front left side of the deck. See Figure 25.
To install the cutting deck, follow the above steps in the opposite order
and manner of removal.
9.
Carefully remove the front deck supports from the deck lift arms.
Figure 25.
10. Carefully unhook the mower’s lift assembly from the rear deck
supports.
11. Use the deck height lever to raise the lift assembly to its highest
position.
12. Remove the wooden blocks from under the deck and gently slide
the cutting deck toward the rear of the machine.
21