A4 insert the joint plate ■ into the joint collar, Ao lock the joint, 40 loosen the joint " lever – Nikon os Speedlight SB-102 User Manual
Page 10: A a insert the arm ® into the joint, 4c position the arm, 4 a lock the arm, Basic operations —continued, Insert the joint plate ■ into the joint collar, Lock the joint, Insert the arm ® into the joint
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BASIC OPERATIONS —continued.
A4
Insert the joint plate
■ into the joint collar®.
While holding the base of the joint
knob against the joint, slide the joint
plate into the joint collar until it is
fully seated.
•
W hen inserting the joint plate into the joint
collar, be sure the flat edges of the joint plate
remain parallel to the flat edges of the joint.
AO
Lock the joint.
Align the flash head position
ing index ®) with the "normal” posi
tion mark on the flash head posi
tioning scale, then turn the joint
knob clockwise until the joint is
locked in position.
•See page 18 lor information about removing
the joint.
40 Loosen the joint
" lever ®.
Turn the joint lever counterclock
wise as tar as it will go to loosen it.
A A
Insert the arm ® into
the joint.
Insert the arm positioning screw @
into the slot in the joint. The arm
can be inserted from either side of
the joint. The normal position is
shown in the photo.
4C Position the arm.
Align the arm positioning
screw with the arm positioning
index ® on the joint by turning the
arm 90°.
4 A Lock the arm.
After aligning the arm posi
tioning screw with the arm position
ing index, turn the joint lever clock
wise as tar as it will go to lock the
arm into position.
•
Normally, the joint is locked at the top of the
arm.
•Before diving, be sure the joint knob and
joint lever are locked tightly.
10