Loading and removing film – Canon EOS 5000 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Loading and Removing Film
How to Load Film
When a roll of film is loaded, it is wound completely on the take-up spool.
Then as each photograph is taken, the film rewinds into the cartridge
frame by frame. The number of frames remaining on the roll of film is
continually displayed.
Please use DX-coded film, as the
camera uses this to automatically
detect and set the film speed. Films
with a speed ranging from ISO 25 to
5000 may be used.
■I Release the command dial lock by
* setting to any position other than L.
Open the back cover by raising the
back cover release.
Tilt the film cartridge as shown in
the diagram to insert.
Infra-red film cannot be used.
The shutter curtain is an extremely high-precision
mechanism and must never be touched. When
loading film, be very careful not to allow your fingers
or the film to come into contact with the shutter
curtain. Otherwise, the shutter curtain may be
damages or bent.