LG LMX21984 - Manual (Page 24)

HOW TO USE
ADJUSTING THE TEMPERATURES AND DISPLAY
Adjust Freezer Temperature
To adjust the temperature in the freezer
compartment, press the FREEZER button to cycle
through the the range of available settings.
Temperature Display
To change the temperature display from Fahrenheit
to Celsius:
O^f
Adjust Refrigerator Temperature
To adjust the temperature In the refrigerator
compartment, press the REFRIGERATOR button to
cycle through the range of available settings.
NOTE: The actual inner temperature varies
depending on the food status, since the indicated
temperature setting is the target temperature and not
the actual temperature within the refrigerator.
Initially set the REFRIGERATOR CONTROL at 37
degrees F and the FREEZER CONTROL at 0
degrees F. Leave them at these setting for 24 hours
(one day) to stabilize. Then adjust the compartment
temperature as illustrated above.
A CAUTION
Display mode setting and its cancellation
1. With the refrigerator door open, keep pressing the
REFRIGERATOR Button and ICE PLUS Button
more than 5 seconds, then it goes to the display
mode with Special Beep Sound with special beep
sound.
2. Perform the same way again to cancel the display
mode.
3. All freezing unit will be turned off at display
mode(Exceplons: Lamp, Display)
Simultaneously press and hold the FREEZER and
REFRIGERATOR buttons for more than 5 seconds.
Do the same to convert back to Fahrenheit.
Display Power-Saving Mode
This function places the display info the Power­
Saving Mode.
^ Simultaneously press thu ; I iEEZER and ICE PLUS
buttons and hold them for 5 seconds until a tone
sounds.
^ All LED lights will turn on and then off.
^ When the Power-Saving Mode is activated, the
display will remain off until the next time the door is
opened. The display will also turn on when any
button is pressed, and it will remain on for 20
seconds after the last door opening or button
selection.
' To deactivate the Power-Saving Mode, press the
FREEZER and ICE PLUS buttons simultaneously
and hold them for 5 seconds until the tone sounds.
#24