Plugging in the power cord and grounding, A warning, Test run – LG WM3070HWA User Manual

Page 18: Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INSTALLATION INSTRUCTIONS

17

Plugging in the power cord and

grounding

Make sure to ground the washing machine to prevent a short

circuit or an electric shock when plugging in.

(Using a 3-prong outle'^

Plug in the electrical outlet without additional grounding.

A

WARNING----------------------------

• The power outlet must be within 60 inches (1.5 m) of either

side of the washer.

• The appliance and outlet must be positioned so that the plug

is easily accessible.

• Do not overload the outlet with more than one appliance.
• The outlet must be grounded in accordance with current

wiring codes and regulations.

• Time-delay fuse or circuit breaker is recommended.
• It is the personal responsibility and obligation of the product

owner to have a proper outlet installed by a qualified
electrician.

• Do not use a worn or damaged power cord or power plug.

Replace or repair it immediately. Failure to do so may result

in death, fire, electric shock, or malfunction.

• Do not modify the power cord and take care not to damage it

when installing or moving the washing machine. Failure to do
so may result in death, fire, electric shock, or malfunction.

• Make sure that the washing machine is grounded.
• Connect this washing machine to a grounded outlet

conforming to the rating prior to use. Failure to do so may
result in fire, electric shock, or malfunction.

• Do not use adaptors or extension cords. The washing

machine should always be plugged into its own individual
electrical outlet which has a voltage rating that matches the
rating plate. Failure to do so may result in fire, electric shock
or disorder.

• Do not damage or cut off the ground prong of the power

cord. Doing so may cause death, fire, electric shock, or
product malfunction.

Test run

Check if the washing machine is properly installed and run a
test cycle.

1 Load the washing machine with 6 pounds of laundry.

2 Press and turn on the right

3 Press [°RiNSE.spi^ to RINSE + SPIN.

4 Press (^.

- The wash cycle starts.

5 Check if water is supplied, that the washing machine

does not rock or vibrates excessively, and that it drains

well during the spin cycle.

- If water leaks during water supply, see page 14,

Connecting the water lines to connect them properly.

- If the washing machine rocks and vibrates excessively,

see page 16, Leveling the washing machine to level it
again.

- If the drain does not work, see page 15, Connecting the

drain line to install it properly.

Advertising
This manual is related to the following products: